L2cat
Zur Navigation springen
Zur Suche springen
l2cat -h
-a autodetect deflate + ppp on first bytes
ppp + deflate:"!p",deflate;"!d"
LF to CR:"!l", strip LF:"!L", transparent:"!8"
-C <destination> slave connect destination -C "OE0AAA-12 OE5XBL"
if no "-C" run as server waiting for connect
-c <cmdline> execute command on connect -c "/bin/bash bash %m %u"
%m=mycall %u=usercall %U=same no SSID %%=%
if no "-c" data path is stdin/stdout
-D <bytes> discard longer ppp frames if pr tx buffer full
-d deflate on
-h this
-i <mycall> <mycall> ... connectable calls -i "OE0AAA OE0AAA-15"
first mycall is digi and used to connect out
-j <1..6> 1:del LF, 2:del LF+CR>LF, 3:CR>LF, 4:del CR
5:del CR+LF>CR, 6:LF>CR in stream from pr
-l convert LF to CR in stream to pr
-L strip LF in stream to pr
-m <0..2> ax25 Monitor to stderr (2 with info)
-n <port> <parm> <value> layer 2 parms, "-n a" set on all ports
parm t:txwait d:dwait o:maxfr f:t1 F:t3
parm I:ipoll n:retr h:halfdup
-P ppp + deflate on
-p <filename> data to/from this device/pipe -p /dev/ttyS0
-R <ms> enable slave "keep connected" with max reconnet delay
(max 4000000ms) (120000)
-r <ms> enable slave "keep connected" with min reconnet delay
and doubles delay each conn try till "-R" (2000)
-U <x.x.x.x:destport:listenport> axudp (autodetect axudp2)
listenport=0 uses a free port
repeat -U for more ports
-v verbous
-V more verbous
-w <n> check dupe axudp frames last n frames or n*10ms